SkyFighter V2 - Information and Plans
Picture		Sponsor Ad
SkyFighter V2 RC Model Designed by: Frank Petty This RC model is an original design by Frank. This model was intended to be a fast, agile flyer and certainly is. The original RC model design was made with 1.9, 15mm EPP and covered with fiberglass weave and colored sealing/packing tape. Other materials such 1/2 inch Bluecore Foam may be used to make this model.
Free Tiled PDF Plan	Free Non-Tiled PDF Plan
	Non-Tiled PDF is not Available at this time
	All plans are free, but if you would like to directly support and encourage the Model Designer, donations are welcome. That or if you just want to buy the designer a beer, or more like a late night coffee, thats cool too...LOL. Any help to support the rcFoamFighters team and their efforts is greatly appreciated.
BASIC RC MODEL NOTES: Wing Span: 23.5 Inches (59.69cm) Length: 30 Inches (71.12cm) AUW: 24 Ounces (680.4gm) (As Built with EPP Foam, Bluecore Foam will result in much lighter model) Servos: 2 Micro (Metal Gear Recommended) Motor: 2212/6 for Basic Setup (Grayson Hobbies Super Mega Jet for Performance Setup) Speed: 90+mph (144kph) depending on motor used Required Radio: Minimum 4-Channel (Recomended 6 channel 2.4ghz) Flight Skill Required: Intermediate to Advanced Building Skill Required: Beginner to Intermediate

Parts And Equipment Ideas For This Model			Sponsor Ad
Brushless Motors
Park Jet Combo Combo Pack, ESC included!	TURNIGY 2836-2350 Note, Motor shaft must be reversed to use this motor.	Super Mega Jet Combo Combo Pack, ESC included!
Brushless ESC's (With BEC)
TURNIGY 40A Plush	TURNIGY 40A K-Force
Lipo Batteries
TURNIGY 2200 3S 30c	Grayson Hobbys 3S 2200ma 30-40C Lipo	rcPerformaxx 2200 3S 40c-80c
Servos
Hextronik MG Servo	Corona MG Servo
Radios and Tape

Copyright rcFoamFighters.com 2010