FF-Predator - Information and Plans
Picture Sponsor Ad
FF-117

Link to HobbyKing.com

FF-Predator RC Model Was Designed By: Tim McMahan
This RC model is loosely based on the Predator/Reaper UAV used by the USAF. The original RC model design was made with Elmers Foamboard, Blue Core Fan Fold Foam and EPS Foam Block for the nose. Other materials such as Depron may be used to make this model.
Free Tiled PDF Plan Free Non-Tiled PDF Plan
Link to Tiled PDF Plans Non-Tiled PDF is not Available at this time
All plans are free, but if you would like to directly support and encourage the Model Designer, donations are welcome. Any help to support the rcFoamFighters team and their efforts is greatly appreciated.
BASIC RC MODEL NOTES:
  1. Wing Span: 60 Inches (152.4cm)
  2. Length: 34 Inches (86.36cm)
  3. AUW: 25 Ounces (708gm) (As Built with FoamBoard and Fan Fold Foam)
  4. Servos: 5 Micro (Metal Gear Recommended)
  5. Motor: Suppo 2212/10 brushless or equal
  6. Required Radio: Minimum 6-Channel (Recomended 6 channel 2.4ghz)
  7. Flight Skill Required: Intermediate to Advanced
  8. Building Skill Required: Beginner to Intermediate
Parts And Equipment Ideas For This Model Sponsor Ad
Brushless Motors

Link to rcSkyFlyer.com
Link to Motor
Tower Pro 2409-18		 Link to Motor
Suppo A2212-10
Brushless ESC's (With BEC)
Link to ESC
Turnigy 30A ESC
Lipo Batteries

Link to HobbyKing.com
Link to Battery
Rhino 1350mA 3S 30C
Servos

Hextronik MG Servo
Corona MG Servo
Radios and Tape

Copyright rcFoamFighters.com 2010